Since we didn’t have a suitable box anymore, we had a weekend break from handicrafts. But we still used the time to place the previous modules once in Nito. So we took out the benches and put the modules in. A strange feeling, it becomes more and more real. Step by step we approach the journey. The modules fit perfectly, even though the hubcap still has to be cut out of the seat\/bed<\/a>. But we don’t want to do that until the new wooden floor<\/a> is in and the right dimensions can be reproduced. Nevertheless, we took measurements to get a feeling of how big the cupboard, the kitchen module and the missing storage box may be. Since the kitchen and the wardrobe also depend on the floor, we decide to make only the storage box and the extendable components of the bed and let the rest rest rest. In April we will not be here anyway and will not have time. In May, on the other hand, it should finally be warm enough to install the insulation.<\/p>\n\n\n\n So we organize cardboard again and sit down to build the box. Another piece of CarTon<\/a> is to be realized. From the principle the box is quite simple, consists only of a bottom, lid and four side walls. We extend the lid with an inner frame, which has the same dimensions as the inside of the side walls. In this way we prevent the lid from slipping, because it is stuck and properly clicks into place. With cardboard it is very easy to cut it to fit exactly. For the lid and bottom we have again used the grid technique and this time we have documented a little bit:<\/p>\n\n\n\n